How To Install A Fridge. Make certain that the floor under the unit is clear and level with the surrounding flooring and can support the weight of the refrigerator and contents included. Next, carry the corresponding door and position it on the bottom hinge pin.
Tighten up the compression nut to connect the water. Selecting the best location for the refrigerator. After disconnecting the current refrigerator, remove its contents before.
If There Is A Water.
Make sure it’s in the ‘off’ position until. Best online cabinets shows you how to make installing wall cabinets over the refrigerator easier and look polished! Connect the threaded end of the hose to the inlet valve.
Follow The Simple Steps Shown In This.
Switch the position of cap screw and assemble the middle hinge by the 5mm allen wrench. Remember, if the flag is facing the direction of water flow, it’s in the ‘on’ position. Installing your refrigerator properly ensures its optimum functioning.
Thread The Screws For The Hinge Through The Screw Holes And.
Turn the valve to shut it off until it stops. After disconnecting the current refrigerator, remove its contents before. Your fridge will come in a large cardboard box.
Drill A Hole Through The Floor, If Necessary, To Connect Your Cold Water Supply Pipe.
The first step to refrigerator installation is cover the floor with cardboard and disconnect the existing appliance to make space for the new. If it gets stuck, take the help of the wrench. If not, pull it out, move it in the required direction and slide it in.
Use A Compression Fitting To Connect The Kitchen End Of The Tubing To The Back Of The Refrigerator’s Water Fill Valve, Usually Located In The Lower Left Corner.
Connect the hot water line with a rubber connector onto one end of your copper pipe. It’s easier to unpack it outside where you have more space. Next, carry the corresponding door and position it on the bottom hinge pin.
Post a Comment for "How To Install A Fridge"